دیکشنری تخصصی مهندسی نفت - نسخه آنلاین

n: the placement of compressors, pumps, cooling systems, treating systems, and so forth, in a series with another unit or units of like design to improve operating efficiency and results.

n: The operation of stopping tripping for circulating drill fluid and cooling thermolabile component part of dynamic drill tool when using dynamic drill tool in hot-well.

n: when drill deep well or top the oil or gas sand ,usually wait to drill to given point then circulating the drill fluid,if no abnormal case then go on tripping.

n: see total pressure. stake a well v: to locate precisely on the surface of the ground the point at which a well is to be drilled. After exploration techniques have revealed the possibility of a subsurface hydrocarbon-bearing formation, a certified and registered land surveyor drives a stake into the ground to mark the spot where the well is to be drilled.

n: A kind of round stainless steel wire,as filter septum in fluid loss experiment when temperature exceed 204 centigrade.

n: Singed the wells number by piling in the measured accurate place .

a condition in which the motor stops rotating when more force is required to rotate the shaft than the motor can produce.

n: the connected joints of pipe racked in the derrick or mast when making a trip. On a rig, the usual stand is about 90 feet (about 27 metres) long (three lengths of drill pipe screwed together). or a thribble.

n: Two or three single joints of drillpipe or drill collars that remain screwed together during tripping operations.

see stand of pipe.

The number of joints of pipe that can be pulled and stood back at one time by the rig, e.g., doubles or triples.