دیکشنری تخصصی مهندسی نفت - نسخه آنلاین

n: the part of a groove on the drawworks drum that changes direction. Grooves run parallel to each other, except in the angle-control section, where each groove is machined at a slight angle. This angled part of the groove causes the wire rope being spooled onto the drum to change direction so that the next wrap of rope on the drum lies in between the wraps of rope already on the drum. Also called a crossover section.

n: The knockout drum that removes the gas invading into the drilling fluid inatmosphere pressure.

n: the reel around which the bailing line is wound. See bailing line.

n: See sand reel.

n: the cable attached to a bailer, passed over a sheave at the top of the derrick, and spooled on a reel.

n: The wire rope connected with bailer, winded to the drum through the pulley on the top of crown block.

n: a hollow drum that contains material to be ground or pulverised, heavy steel or ceramic balls, and a liquid such as water. The drum is rolled or agitated so that the balls crush or polish the material as they roll about.

a small, usually hand driven pump with a long dip tube used to move chemicals from drums and barrels.

n: a part of the brake mechanism consisting of a flexible steel band lined with a material that grips a drum when tightened. On a drilling rig, the brake band acts on the flanges of the drawworks drum to control the lowering of the travelling block and its load of drill pipe, casing, or tubing.

n: Bourdon plate whose inner surface is installed with several brake blocks at definite interval.

n: the surface on a winch, drum, or reel to which the brake is applied to control the movement of the unit by means of friction.

n: a section of the lining of a brake band shaped to conform to the curvature of the band and attached to it with countersunk screws. See brake band.

n: The heatproof, abrasion proof, and high friction coefficient blocklike component part. Made by material pressure stencil or plait pressure stenci. Fixed in the inner surface with head screw. The friction produced by contact of brake drum when working.

n: Matched with brake block and brake staple. It is the circular ring particular cast steel connected with two ends of cylinder.