refinaryrig

دیکشنری تخصصی مهندسی نفت - نسخه آنلاین


بزرگترین دیکشنری مهندسی نفت با بیش از 20 هزار کلمه ، مصور و با قابلیت تلفظ



نمایش نتیجه 1 تا 10 از 146 نتیجه یافت شده برای second:
n: the force in dynes that a stationary flat plate with a surface area of 1 square centimetre exerts on a similar parallel plate 1 centimetre away and moving in its own plane with a velocity of 1 centimetre per second, the space between the plates being filled with the liquid in question. It is a measure of the resistance that the liquid offers to shear. absolute error n: the difference between the result of a measurement and the true value of the measured quantity as determined by means of a suitable standard device.

n: the property by which a fluid in motion offers resistance to shear and flow. Usually expressed as newton seconds/metre.

the measure of a fluid’s ability to resist flow without regards to its density. It is defined as a fluid’s kinematic viscosity multiplied by its density.
گران روی مطلق

(A) n: the fundamental unit of electrical current;1 ampere = 6.28 x 1018 electrons passing through the circuit per second. One ampere delivers I coulomb in 1 second. ampere-hour n: a unit of electricity equal to the amount produced in 1 hour by a flow of I ampere. See ampere.

a secondary fault, often in a set, with opposite direction to the primary fault.

n: a second number whose logarithm is the first number. See logarithm.

a secondary fault, often in a set, with an opposite direction to the primary fault.

a large, load supporting formation that may serve to reduce the total overburden load on a pay zone. These formations may cover hundreds of square miles over a basin. A second use is as a semi-stable structure of sand grains around a perforation or other

n: a transformer with only one winding, part of which is used for either the primary or secondary conductor, and part of which is used as both primary and secondary conductors.

n: A classified float collar installed in the same casing when three-level cementing. Used for secondary cementing. See regular stage collar.

n: If bit load continues increasing after buckling of first order, bending shape will change piecemeal and tangency point will move downward.


۱
۲
-

© ۱۳۹۲-۱۳۹۷ این اثر شامل قانون حمایت از مولفین بوده و هرگونه کپی برداری از آن ممنوع است.